Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Sliding glass doors
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimatePGT Window Replacement: The Enterprise Owner’s Guide
Window and door replacement in Enterprise using PGT products runs about $850 to $1,750 per opening installed, depending on series, glass package and whether the frame is rebuilt or swapped. Complete window replacement is scheduled work, not an emergency call, so we plan a date that fits your week and finish most single-opening replacements in one visit. The homeowner usually ends up on this page the same way: a latch that won’t catch, a seal that lets a rattle in at night, a sash that will not sit level in the frame anymore. If your panes are fogged or an aluminum sliding door is fighting you every time you open it, the failing part is almost always in the frame, not the catalog number you wrote down.
Which PGT Models This Applies To
PGT makes several window lines that fit these brackets, and knowing which one you have changes the answer. The legacy WinGuard series and the current WinGuard 30, 35 and 45 impact lines are what most Clark County homes carry, alongside the older Winguard and Aluminum Series patio doors. The most common compatibility mistake we correct is homeowners ordering a replacement sash or hardware set based on the sticker on the exterior frame, when the part is actually matched to the glazing date code on the interior spacer or the serial embossed on the edge of the panel. Take a photograph of both labels before you call anyone, and compare them. Original factory parts for older PGT lines can be discontinued or backordered, so for a house built pre-2005, a factory-equivalent aftermarket match is often the only option. Local glazing shops can cut glass to size, but the frame, gaskets and hardware still have to line up. We’ll never order a PGT part sight unseen. We measure the opening twice, and the replacement is quoted against the label we actually read on your unit. TruePane is an independent installer, not affiliated with PGT, so the quote on paper is ours and the warranty is registered in writing.
Styles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
Signs Your PGT Window Replacement Is Failing
Every one of these is repairable, but the underlying cause matters more than the symptom. A replacement window only lasts if the part and the frame are matched correctly to begin with.
- Fogging between the panes. The sealed glass unit has lost its dry gas fill; the part is the insulated glass, not the frame. In Enterprise’s heat and desert dust, seal failure usually shows on the sun-facing side first.
- Draft or whistle around the frame. The weatherstripping has compressed or the sash has dropped out of square. It is a hardware and alignment issue, not a candidate for caulking alone.
- Latch, lock or handle that won’t engage. The lock mechanism has worn or the keeper has shifted. This is the part most owners try to fix first; it usually means the sash stop has moved.
- Condensation on the inside of the glass. Moisture is getting past the interior perimeter seal. On impact glazing with a heavy interlayer, a small condensation line can develop into a full fogging within a year.
- Sash that sticks or won’t slide. The rollers, track or tilt mechanism have worn or the frame has shifted. Sliding PGT units set into standard frames are the ones we see with track wear fastest.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed prices for PGT window replacement in Enterprise are best thought of as a range, not a single number, because the part that failed decides the work. A single fixed or slider pane in a standard opening is the low end. A large impact-rated unit or a patio door set into a stucco wall is the high end. Every quote we write is line-item on paper: part, glass, labor, disposal and the permit line if a structural opening is involved. Nothing appears on the final invoice that wasn’t on the estimate. The range covers removal of the failed unit, new part set and sealed correctly, and the workmanship warranty written out before the installer leaves. A standard manufacturer’s warranty on the glass and hardware is registered with PGT in writing, and the durations are stated in your paperwork. We quote several manufacturer lines side by side so you can see what the cost buys.
DIY or Call Us?
You can safely check the label, measure the visible glass by width and height in millimetres, photograph the interior date code and look for condensation or damage. That takes five minutes and makes the call easier. What we don’t recommend is prying a sealed unit out of a vinyl or aluminum frame on your own. An impact-rated PGT unit often carries a heavy laminated interlayer and can weigh significantly more than a standard window. Dropped or mis-caught, it’s a two-storey fall and a hospital bill. Trying to reseal a failed unit from the outside never holds in Enterprise’s summer heat. The honest answer: check the labels, write down the measurements, and let us handle anything involving glass removal, frame adjustment or impact hardware. Most jobs done right on the first visit, and one call gets a straight answer.
FAQs
How long does a PGT window replacement last? A properly installed replacement window in Enterprise typically lasts 20 to 30 years, with the insulated glass unit being the first piece to show wear in the local climate. PGT’s impact lines generally hold their seal longer than standard glazing because of the laminate and heavier frame. Call (844) 629-7617 and we’ll walk through the life expectancy for your specific series.
Can I repair my PGT window instead of replacing it? Sometimes yes, and it’s always worth asking first. Fogged glass, a failed lock or worn rollers can often be fixed without replacing the whole unit. If the frame itself is out of square or the sash has been re-cut, replacement is the honest answer. Call (844) 629-7617 for an assessment before you commit to a full swap.
How long does the swap take? Most single-window replacements are done in one visit, usually a few hours. A larger impact unit or a patio door set into a stucco wall can run a full day. We schedule the work so the opening is not left unfinished overnight. Call (844) 629-7617 to get a realistic window on your calendar.
How do you source the PGT part? We read the label on your actual unit, then match it to the manufacturer line and the correct hardware or glazing spec. If the factory part is discontinued, we source a compatible replacement matched to the same dimensions. TruePane is an independent installer and not affiliated with PGT; the quote you sign is ours.
If your PGT window has fogged glass, a lock that won’t catch or a seal that’s failing, the real question is which part is actually gone and what it costs to fix. Call TruePane Windows & Doors Enterprise at (844) 629-7617 for a free, no-pressure estimate. We answer the phone with a live person, we’ll measure twice, and we’ll write the quote on paper before we set a date.
Written by the team at TruePane Windows & Doors Enterprise, serving Enterprise and nearby areas.